Regency Liberty L965E Large Gas Fireplace - Manual (Page 26)

Figure 1: Heat Distribution Kit’s Parts Diagram.
Please ensure that your Heat Distribution Kit has not been
damaged.
IMPORTANT: When installing the Heat Distribution Kit,
the clearances shown in Figure 12 must be maintained.
Rear of the Unit
Hot Air Duct Angle
Hot Air Duct
Duct Cover Plate
Rear Standoff
Rear of the Unit
Item Description
1 Hot Air Duct
2 Hot Air Duct Angle
3 Fireplace Vent Duct
4 Fan Bezel
5 Front Access Cover
6 Fan
7 Fan Housing Assembly
8 Fan Housing Mounting Bracket
9 5” Round Flex Line Air Duct
Figure 2: Remove the duct cover.
1. Remove the rear standoff and the duct cover plate from
the back of the unit.
Figure 3: Install the hot air ducts.
2. Insert the hot air duct and the hot air duct angle into the cut out (refer to Figure 3). Secure
the ducts to the back of the fireplace through the pre-drilled holes with hex head screws.
3. Cover the hot air duct opening with the Fireplace Vent Duct (refer to Figure 4). Push the
vent duct kit against the back of the fireplace and secure it in place with five (5) ¼” HWH
self drilling screws.
HEAT DISTRIBUTION KIT INSTALLATION
26
Regency L965E / HZ965E Gas Fireplace
INSTALLATION