Stainless Works Ford Raptor 6.2L SuperCrew 2011+ Headers - Manual (Page 4)

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
FOR HEADERS TO STAINLESS WORKS EXHAUST
52. Install X pipe using (2) 3” clamps. This step is not required for the Raptor Truck
Lightning style exhaust which exits in front of the rear tires (P/N FTRPT10CBFT).
53. Next follow the instructions for catback installation omitting the Y-pipe installation in the
catback.
54. Re-connect battery. Be sure to have adequate clearance around all wires, hoses and lines.
If anything is in contact with the exhaust system, it will melt. Make sure to have at
least ½” of clearance and wrap any suspect areas with DEI thermal barrier wrap.
55. After double checking for clearance and making sure all lines, wires and hoses are
secured, drive the car for 10-20 miles and re-check all clamps and clearances. Your
system may be tack welded at the joints/ clamps to reduce shifting of the system during
heating and cooling cycles. Make certain to disconnect the battery before performing any
welding.