Stainless Works Chevy Camaro 2010-14 SideBurners Modular-Exhaust - Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
INSTALLATION INSTRUCTIONS FOR 2010+ CAMARO V8
SIDEBURNERS SIDE EXHAUST
Thanks for purchasing Stainless Works Sideburners Side Exhaust for your 2010+ Camaro
V8. We have gone to great pains to make sure that our exhaust systems fit and sound
great. Please follow these steps to ensure that your installation goes as planned.
1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket
maker as an option to or in conjunction with the use of factory gaskets. The
recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or
Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons.
4. Remove the black OEM cross brace that extends across the factory resonator and
replace with stainless steel Sideburners cross brace using OEM bolts and tighten.
This shorter brace will provide proper clearance for the routing of the Sideburners
exhaust tubes.
5. Temporarily hold up one side of the new exhaust, locating where the tip lines up,
and where the front of the Sideburners will locate on the factory exhaust. Use the
Sideburners to mark the location for the new exhaust tube, and mark the old
exhaust.
6. Drill a ¾” dia. hole in the old exhaust using a hole saw or stepped drill (see photo
below)