Stainless Works Ford Raptor 2011+ 6.2L Lightning Exhaust - Manual

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183
2011+ FORD F-150 RAPTOR 6.2L SUPERCREW (LIGHTNING
STYLE SIDE EXIT) CATBACK EXHAUST INSTALLATION
INSTRUCTIONS
Thanks for purchasing the Stainless Works Catback Exhaust for your 2011+ Ford F-150
Raptor 6.2L Truck. We have gone to great lengths to make sure that our exhaust systems
fit and sound great. Please follow these steps to ensure that your installation goes as
planned.
1. Stainless Works recommends the use of Hi-Temp RTV silicon gasket maker as an
option to or in conjunction with the use of factory gaskets. The recommended
RTV is Valco Sensor Safe Aluminum All in One or Permatex Sensor-Safe P/N
101BR or 27BR, available at NAPA and other retailers.
2. Disconnect the battery before starting work on the exhaust system for your
vehicle. Reconnect the battery when the job is completed.
3. Your exhaust system can be installed by a weekend warrior but the use of a lift is
recommended for ease of installation. If using a jack, the vehicle must be placed
on a level hard surface and jack stands are required for safety reasons.
4. Unbolt the factory exhaust at the 2 bolt flange - (2) 10 mm bolts.
5. Remove old exhaust from all hangers then remove from the truck.
INSTALLING THE CATBACK TO MANIFOLDS ONLY
6. Loosen the clamp at the front section of the old exhaust. Disconnect and remove
this short section.
7. Mark this pipe section to 7-1/2” from the flanged end for cutting. See picture
below.