Opticon PHL 1300 - Manual (Page 21)

21
No communication from the cradle to the
device, or data is transmitted distorted or
corrupted.
Power indicator of the cradle is not green.
Check if the battery case cover of the
PHL1300 is closed properly.
Clean the optical interface window of the
cradle and/or terminal, and try again.
Check all cables.
When the power indicator is still not
green, the cradle needs service.
No data transmitted
The cradle will only work if connected to
a PC.
Clean the optical interface window of the
cradle and/or terminal, and try again.
Data is corrupted, or no data is
transmitted.
Is the proper baudrate selected?
The computer needs the same baudrate
as the terminal.
Clean the optical interface window of the
cradle and/or terminal, and try again.
The terminal looses data when the battery
pack is removed for a short period.
The backup battery is empty.
Replace the Lithium CR2032 battery by
a new one.
?
?
?
?
When the terminal has a problem with
reading the label:
The resolution of the bar code is too
high.
Decrease the distance between the bar
code and the terminal.
The angle between the label and the
terminal is too high.
Change the angle between the bar code
and the terminal.
The distance is too far or too close.
Change the distance between the bar
code and the terminal.
The bar code is larger than the laser
beam.
Try moving the terminal a bit further away
from the bar code.
The read window is dirty.
Clean the read window of the terminal.
The type of the bar code label is not
enabled.
Enable the bar code symbology in the
application program.
?
?
?
?
?
?
U
SER
’
S MANUAL
PHL1300
TERMINAL
/ IRU1300
CRADLE
7.1 COMMUNICATION
PROBLEMS
7.2 READ OPERATION
PROBLEMS