MTS SWIFT 50 GLP Sensor - Manual (Page 29)

Road and Track Vehicles
SWIFT 50 GLP Sensors Installation Installing the Transducer 29
Road and Track Vehicles
Equipment required
This procedure requires two people. To install the SWIFT 50 GLPS or SWIFT 50
GLPT sensor, you will need the following equipment:
• Spindle adapter spacers (see next figure)
• Modified rim (see next figure)
• Anti-rotate assembly (including customer-supplied mounting arm)
• Small set of metric hex-head wrenches
• Tube bender for the restraint tube
• Tube cutter
• Metric socket head drive set (up to 14 mm) with extension
• Molykote g-n paste, 2.8 oz. tube (MTS part number 011-010-217)
• Nikal based anti-galling compound (MTS part number 011-354-902)
• Transducer mounting bolts (per transducer)
For dual rims
16 size M16 X 1.5 mm
8 size M10 X 1.5 mm
4 size M5 X 0.5 mm
lug nuts and shim washers
For front rims
16 size M16 X 1.5 mm
8 size M10 X 1.5 mm
4 size M5 X 0.5 mm
lug nuts and shim washers
• For dual rims
Slip ring extension assembly
Four size M12 X 1.75 mm X 30 mm long bolts
• Slip ring assembly fasteners
Four size M8 X 1.25 mm X 20 mm long bolts
• Torque wrenches, capable of the following ranges:
2.3–23 N•m (20–200 lbf•in)
24–74 N•m (18–55 lbf•ft),
203–815 N•m (150-600 lbf•ft);
108–325 N•m (80–240 lbf •ft)
93 N•m (69 lbf•ft)
• Cables (transducer and BNC, plus customer-supplied from transducer
interface to data recorder)
• Tie wraps
• Data recorder
• Power supply–12 V DC or optionally 24 V DC 1 (for example, a truck
battery)
1 If 24 Vdc compatible electronics was ordered at time of purchase.