MTS Series 793 Controller - Manual (Page 88)

MTS Series 793 Controller Overview
About Setting Up a Practice Test
Perform a Practice Test 88
If you are going to set
up your controller
If you are installing Series 793 Software on your system and setting up your
controller yourself, you'll need to do the following before performing the practice
test:
• Install Series 793 Software
• Set up a Project (typically performed during software installation)
• Create a station configuration file
• Calibrate the sensors
• Perform servovalve adjustments
• Tune the system
To perform the Series 793 Software installation, see the Installation Instructions
readme file on the Series 793 System Software CD, and follow the installation
wizard.
To perform the remaining tasks, see the MTS Series 793 Tuning and Calibration
manual.
You may also find it necessary to see the following manuals:
• MTS Series 793 Utility Software manual—To setup or edit the hardware
interface file to reflect any hardware changes to your system.
• MTS Series 793 Control Software manual—To find detailed information
about using Series 793 Software controls.
• Other MTS manuals—You can receive additional MTS manuals that
provide instructions for maintaining and operating your test system.