MTS Series 793 Controller - Manual (Page 44)

MTS Series 793 Controller Overview
Operational Overview
Operation Concepts 44
Assigning Parameters to the Station Configuration
Station
Manager
application Station
Config
file Parameter
set 1 Parameter
set 2 Parameter
set 3
Next, you load a station by selecting a Station Configuration file with the Station Manager application.
You assign parameters of the resources in Station Configuration file to optimize performance according
to your test requirements.
PARM PARM PARM
Creating a Test Design
Station
Manager
application Station Config
file with
Parameter set MultiPurpose
TestWare
application Test
Procedure
file 1 Test
Procedure
file 2 Test
Procedure
file 3
Next, you create a test program. To do this, you select your Station Configuration file and desired
parameter set with the Station Manager application. Then from the Station Manager application, you
select the desired test design application, such as Basic TestWare or MPT, and create test design files.
PARM
Running a Test
Station
Manager
application Station Config
file with
Parameter set MultiPurpose
TestWare
application Test
Procedure
file Test Data
file
Finally, with all of the files open, you start the test from the Station Control panel of the Station Manager
application. Test Data files are generated according to the type of test design application you used to
create your test design file.
PARM