Metal Sales Image II Installation - Manual (Page 25)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 6/2011
25
Valley Detail
Eave flashings must be installed before and Valley flashings. All
Valley flashings must be installed prior to panel installation. If
two or more Valley flashings are required, Valley flashing must be
installed working from eave to peak. It is recommended that ms-HT
underlayment be installed under Valley flashing for added moisture
protection.
1. Install Valley flashing against substrate from the low end to the
high end. To hold Valley flashing in place, fasten to substrate
with #8-18 x 3 /
4
" Truss Head Woodscrews, 4' o.c.
2. Apply a row of Double Bead Tape Sealant across both sides of
Valley flashing approximately 5" from center of valley.
3. Miter cut panel and install first panel so that the panel end
is located the proper distance from the center of the Valley
flashing.
4. Fasten Image II panel with (4) #9-16 x 1" Woodscrews through
Double Bead Tape Sealant, flashing, and into the solid sub-
strate as shown below.
5. If two or more Valley flashings are required, lap the Valley
flashing over the previously Valley installed flashing by a
minimum of 2" placing 2 beads of Tube Sealant between the
Valley flashings.
Image II Panel (4)
Moisture Barrier
#9-16 x 1" Woodscrew (5)
Tube Sealant in flashing laps (6)
Valley (1)
Double Bead Tape Sealant (3)
3"
Min.
Optional Valley
with Offset Cleat
3"
Truss Head Woodscrew, 4' o.c. (2)
(X) Numbers indicate sequence of installation.