Metal Sales Image II Installation - Manual (Page 17)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 6/2011
17
All Valley flashings must be installed prior to panel installation.
1. Position Valley on roof, working from the low end to the high
end.
2. Attach Valley to substrate with #8-18 x 3 /
4
" Truss Head
Woodscrews, 4' o.c.
3. Make sure Truss Head Woodscrews are positioned as to be
covered by the Image II Panel when installed.
Note: If two or more Valley flashings are required, lap the Valley
flashing over the previously installed Valley flashing by a minimum
of 6" placing 2 beads of Tube Sealant between the flashings.
Step 2
Installing Valley Flashing
Moisture Barrier
Valley (1)
Truss Head Woodscrew,
4' o.c. (2)
Installation Procedures
(X) Numbers indicate sequence of installation.