Landoll 3130 SERIES WING PACKER - Manual (Page 49)

4-9 TRANSPORTING THE PACKER
4-9.1 Prior to Transport
a. Utilize transport chains. The transport chain
should be adjusted so that the tongue of the
towed machine will not touch the ground in
case of loss of the hitch pin.
b. Place SMV emblem into the holder.
c. Insect the two red reflectors on the rear cor-
ners of the machine and the amber reflector
on the front left corner of the machine. Be
sure all three are in place and free from dust
and other obstructions.
d. Make sure light harness is properly con-
nected and all the lights are visible and work-
ing.
e. Secure the tractor drawbar so that it will not
swing during transport.
4-9.2 Procedure For Transporting
a. After the packer has been properly hitched
to the tractor:
b. Fold wings to transport position.
c. Raise the machine and install pin in cylinder
lug to lock the machine in the raised position
(See Figure 4-3).
4-9.3 Returning To Work Position After Trans-
porting
a. Extend the transport cylinder to relieve the
pressure on the transport pin.
b. Remove the pin and relocate in the axle lift
hole (See Figure 4-4).
c. Unfold wings and lower the machine. The
unit is now in the working position.
4-9.4 Transport And Wing Cylinders
a. Always be sure the tractor hydraulic oil res-
ervoir is filled to the proper level.
WARNING
STAY CLEAR OF FOLDING WINGS
WHEN BEING RAISED OR LOWERED,
OR WHEN IN AN ELEVATED POSITION.
BE CERTAIN THE HYDRAULIC SYS-
TEM IS FULLY CHARGED WITH OIL
BEFORE USE. AIR IN THE HYDRAULIC
SYSTEM CAN RESULT IN UNCON-
TROLLED MOVEMENT OF THE WINGS
DURING RAISING AND LOWERING OP-
ERATION.
4-9.5 Cylinders have to be purged of air before
initial operation or when oil has been drained
from the cylinders or hoses. Disconnect the
cylinders at the rod end. Cycle the cylinders
by fully extending and retracting the rod sev-
eral times. Reconnect the cylinders.
4-9
Figure 4-3 Lockup Pin for Transport
Figure 4-4 Axle Lift Adjust for Transport