Landoll 3130 SERIES WING PACKER - Manual (Page 21)

3-10 ELECTRICAL INSTALLATION
3-10.1 Position taillight tube between 2 feet and 5
feet from centerline of the frame using u-
bolts, 3/8 flat washers, split lock washers,
and hex nuts. Taillight tube should extend to
the rear of the frame. Be sure lights can be
seen from the rear of machine (See Figure
3-7).
3-10.2 Attach tail light brackets to tail light tubes
using 3/8-16 x 1-1/2 hex head cap screws,
flat washers, split lock washers, and hex
nuts.
3-10.3 Position the red lamps in the tail light
brackets so that they may be seen from the
rear.
3-10.4 Position the amber lamps in the mounting
brackets welded to the frame. One set of
amber lamps will mount so that they can be
seen from the front. The other set will mount
so they can be seen from the rear.
3-10.5 Install the light harness between the lights
connecting to red lights at the rear of
machine.
3-10.6 Connect each flasher extension harness
to the light harness. Connect flasher exten-
sion harness to amber lights located to front
and rear of machine.
3-10.7 Connect main harness to light harness
and route along tongue toward tractor. Allow
adequate harness length to allow for adjust-
able length tongue and to connect to tractor.
3-10.8 Insure the harnesses are not kinked,
stretched, or rubbing against sharp edges.
Use plastic ties as needed to hold harnesses
in place. Check for proper clearance when
the machine is in raised or lowered positions.
3-9
Figure 3-7 Electrical Installation