Landoll 875 Series Tilloll - Manual (Page 47)

ASSEMBLY INSTRUCTIONS
3-31
Lubrication
The 875 Series Tilloll must be lubricated before using it
for the first time, and at regular intervals thereafter. Use a
standard multi-purpose grease. See “Lubrication” on
page 4-9 to lubricate your 875 Series Tilloll.
Decal Placement
Decals are extremely important for naming purposes and
for alerting others to the presence of the machine.
PLACE ALL DECALS on the Tilloll as shown in Figures
3-18 and 3-19. Center them as nearly as possible
between the top and bottom on the frame bar.
Sometimes, shank spacing may position a tool frame too
near the end of the frame bar to place a reflective tape
square exactly as shown. Then place the square
between the U-bolts on the tool frame as near the proper
location as possible. A red reflective square is attached
to the rear of the left- and right-hand end tool frames at
the factory. If any decals become unreadable, or are
destroyed during use, get replacement decals from your
Landoll dealer as soon as possible, and replace them on
the machine.