Landoll 875 Series Tilloll User Manual
Model 875 series tilloll operator’s manual
Table of contents
Document Outline
- Introduction
- Standard Specifications
- Table 2-1: General Torque Specifications
- Table 2-2: Hydraulic Fitting Torque Specifications
- Figure 2-1: 875-10 Shank Placement Assembly
- Figure 2-2: 875-13 Shank Placement Assembly
- Figure 2-3: 875-15 Shank Placement Assembly
- Figure 2-4: 875-15F Shank Placement Assembly
- Figure 2-5: 875-18 Shank Placement Assembly
- Figure 2-6: 875-21 Shank Placement Assembly
- Figure 2-7: 875-25 Shank Placement Assembly
- Assembly Instructions
- Figure 3-1: Frame Assembly - Rigid Models
- Frame Assembly - Rigid Models
- Frame Assembly - 15’ Fold Model
- Frame Assembly - Wing Models
- Shank, Clamp, and Sweep Assembly
- Gauge Wheel Installation
- Hydraulic Lift Installation - Rigid and 15’ Fold
- Hydraulic Lift Installation - Fold Models
- Hydraulic Fold Installation - All Fold Models
- Disc Gang and Spray Shield Installation
- Reel Assembly Installation
- Harrow Assembly Installation
- Pull Hitch Installation - 15’ Fold Model
- Pull Hitch Installation - All Other Models
- Warning Lights Installation
- Lubrication
- Decal Placement
- Operation and Maintenance
- Troubleshooting Guide