Landoll 875 Series Tilloll - Manual (Page 29)

ASSEMBLY INSTRUCTIONS
3-13
Hydraulic Fold Installation - All
Fold Models
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Install wing fold bracket to wing hinge using hinge
pivot bolt through bracket, wing hinge, second
bracket, and hex lock nut. Install base end of fold
cylinders to main frame cylinder anchor using
cylinder pin and hair pins. Install rod end of fold
cylinders to wing fold brackets inserting hinge pivot
bolt through wing fold bracket, flat washer, yoke,
roller, yoke, flat washer, wing fold bracket, and hex
lock nut. Do not overtighten bolts. Linkage must be
snug, but move freely (See Figures 3-2 and 3-4).
2. Install short and flat wing supports on wings using
u-bolts and 5/8-11 hex lock nuts. See Figures 2-1
through 2-7, 3-2, and 3-4 for locations.
3. Install 90
o
elbows with restrictors into base and rod
end of each cylinder.
4. Install hoses (See Figures 3-9 and 3-10. See
Table 3-3 and Table 3-4).
Table 3-3: Hydraulic Hose Installation - 15’ Fold Model
ITEM PART NO. HOSE LENGTH (MODEL USED)
A 1413183 3/8 X 103 (875-15F)
B 1413572 3/8 X 107-1/4 (875-15F)
C 137602 3/8 X 27 (875-15F)
D 1-397-010369036 3/8 X 36 (875-15F)
E 123547 3/8 X 56 (875-15F)
F 71508954 3/8 X 22 (875-15F)