Landoll 875 Series Tilloll - Manual (Page 41)

ASSEMBLY INSTRUCTIONS
3-25
Pull Hitch Installation - 15’ Fold
Model
1. Install pull hitch assembly to frame using hitch pins
and 1/4 x 2-1/2 cotter pins (See Figure 3-15.)
2. Attach radius rod assembly to mast using extended
cylinder pin and 1/4 x 2 cotter pins.
IMPORTANT
The radius rod affects two adjustments:
• It locates the pull hitch clevis at the proper height
for the tractor draw bar.
• It levels the machine. lengthening and shortening
can be accomplished by using the radius rod
handle.
3. Install jack on pull hitch using hitch pin w/ chain
included.
IMPORTANT
Remove the 1/4 hair pin and trail pin before folding
and unfolding. Pins must be in place while operating
or transporting equipment.
Pull Hitch Installation - All Other
Models
1. Install pull hitch assembly to frame using hitch pins,
flat washers, and 1/4 x 2-1/2 cotter pins (See
Figure 3-16.)
2. Install hitch ring assembly to pull hitch assembly
using 1-8 x 8 or 1-8 x 8-1/2 hex head cap screw, flat
washer, hitch bushing, and hex lock nut.
3. Install radius rod assembly attached to pull hitch to
mast using extended cylinder pin and 1/4 x 2 cotter
pins.
IMPORTANT
The radius rod affects two adjustments:
• It locates the pull hitch clevis at the proper height
for the tractor draw bar.
• It levels the machine. lengthening and shortening
can be accomplished by using the radius rod
handle.
4. For all fold models, install hose bracket on pull hitch
with special nut and 1/2-13 hex nut. On all rigid
models, install hose bracket and hose bracket mount
to pull hitch assembly using 1/2-13 x 1-1/2 hex head
cap screw, hex lock nut, special nut, and hex nut
(See Figure 3-16.)
5. Install jack to pull hitch assembly using hitch pin with
chain included.