Kisan Electronics SN-3M User Manual
Page 9
Page - 7
P
P
1
1
1
1
5
5
W
W
-
-
A
A
2
2
W
W
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
n
Remove the 2-pin connector from the Hi-beam
bulb.
o
Insert the modulator’s 2-pin male plug, as
shown here, in the original connector.
Verify the POLARITY. Red wire is for power.
Reversing this connection will inhibit modulation.
p
Vinyl boot should be used to stretch over the
original plug of the bulb for weather protection.
q
Male pins of the plug are slightly thicker to allow
a secure and tight fit. For added protection you can
use a zip-tie to hold this connection tight.
r
Now you can plug the matching
connector of the modulator to the Hi-beam
bulb.
NOTE! Pin spacing is 0.40” (10mm) for the
9000 series bulbs.
Appropriate pathBlazer should be used for
proper connections. Do not force or bend
pins to make it fit.
The Daylight Sensor can be flush mounted
or you can zip–tie it. Refer to the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.