Kisan Electronics SN-3M User Manual
Page 42
Page - 40
OPERATION QUESTIONS:
Q: My pathBlazer won’t modulate in Lo-beam. Why?
A: All plug-in versions of pathBlazer are designed to modulate in the Hi-
beam only. Even for the splice-in versions, we highly recommend for the
Hi-beam modulation. It is much easier to control the modulation in daytime
with the Hi-beam.
Q: I have installed my pathBlazer according to the instructions, but it
won’t modulate. Why?
A: pathBlazer circuit is designed to be on by default. Properly connected
and programmed Daylight sensor forces the unit to modulate. Check
connections, including the splice-in versions for the correct polarity and
make sure you are in sufficient daylight with Hi-beam on.
Q: I have installed the Dual Hi/Lo (DHL) version of pathBlazer, and I see
that both Lo and Hi beam modulate in daylight. What will happen at night?
A: At night or in the dark, the modulation will cease and both beams will
stay on steady – if the Hi-beam is switched on.
Q: I have installed the splice-in version of the pathBlazer and everything
is hooked-up, yet the Hi-beam won’t even come on. What’s wrong?
A: A good ground connection is required for the pathBlazer circuitry to
work. Without ground, or with an isolated ground point, the unit will not
start.
LEGALITY QUESTIONS:
Q: Is this thing legal?
A: Yes, it is legal in all of United States and through out Canada. A
summary of the Federal Code is printed on the inside cover.