Kisan Electronics SN-3M User Manual
Page 17
Page - 15
y This is SPECIAL unit for 12V AC headlights only. NOT FOR 12V DC
y Keep the heat sink of the unit away from plastic or fuel lines.
P
P
1
1
1
1
5
5
W
W
-
-
A
A
C
C
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
For a simple plug-in installation, select appropriate adapter to fit the
headlamp on your scooter. On most models, access to the plug of the
headlamp is possible simply by reaching it from underneath the front
fairing or from behind the dash. Or you may have to remove the headlight
nacelle.
n
Unplug the 2-pin headlamp connector and plug the H7 adapter on the
bulb.
o
Now you can plug the original connector on the back of the adapter.
VERIFY POLARITY of the connector as shown above.
Use the Velcro pad to mount the unit nearby and attach the Daylight
Sensor. It can be flush mounted; or it can be zip-tied – facing the sky.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.