Kisan Electronics SN-3M User Manual
Page 15
Page - 13
yReverse polarity of either the plug or the socket will inhibit modulation.
yThe latch of the original connector does not engage with the modulator.
P
P
1
1
1
1
5
5
W
W
-
-
A
A
6
6
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
n
Remove the 6-pin connector from back of the headlight assembly.
o
Install the 6-pin plug in its place. The flat side of the visible PCB lines-
up with the flat side of the headlight assembly socket.
p
Now you can plug the original 6-pin connector to the male pins of the
modulator connector. The flat side of both connectors match-up for correct
polarity.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.