Kisan Electronics SN-3M User Manual
Page 33
Page - 31
n
Remove (2) Phillips screws, which
are hidden under the rubber covers of
the side view mirrors
o
Remove (4) 10mm screws & grille
1
1
5
5
0
0
G
G
W
W
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
Remove the clip and twist the 4-pin
connector around to plug the
pathBlazer in-line. The female socket
can only go in one-way.
Push the connectors in so that they
are completely flush, as shown.
Feed the Daylight Sensor through the
square opening toward the ignition key
panel. It can be flush mounted near
the Ignition Key. Otherwise it can be
zip-tied.
Refer to the Instructions on the following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard
.
p
Headlight assembly moves out
In-line
Plug-in
Install