Kisan Electronics SN-3M - Manual (Page 23)

Page - 21
P P 1 1 1 1 5 5 W W - - H H 3 3 I I N N S S T T A A L L L L A A T T I I O O N N : :
H4 Adapter:
For special applications with a very small
headlight nacelle, this adapter allows a plug-
in installation for an H4 bulb.
¼” Tab Connectors:
Access to the 1-pin H3 or H1 bulb may not be
necessary. By locating the hi-beam wire outside of
the headlight housing, it is possible to plug-in or
splice-in the Input/Output as shown here. Extra
male and female ¼” tab connectors are supplied, if
you have to cut the wire.
You can also splice the power wire
directly in the Input/Output terminals of
the unit. The protective Vinyl boot to
cover the screw-in terminals can be
removed. When connecting this way, if
the polarity is reversed, it will inhibit
modulation. The ground wire to the
middle terminal must be attached.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
„ Choosing appropriate location for mounting the Daylight Sensor (pg-36)
„ Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.