Kisan Electronics SN-3M User Manual
Page 13
Page - 11
P
P
1
1
1
1
5
5
W
W
-
-
A
A
4
4
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
If the lo-beam stays
ON, when you select
the hi-beam – simply
install the unit in-line
with the matching
male/female
connectors.
If the lo-beam goes
OFF, you can install a
Scotchlok to join the
Yellow and Blue wire to
keep the lo-beam on
while the hi-beam is
selected.
For 2008 models, the 4-pin connector requires different pin-out.
Use P115W-A4-W for that application.
Daylight Sensor can be flush mounted or you can zip–tie it. Refer to the
Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.
Dual H4 Adapters
This unit is designed for the XB12 series: Lightning, Firebolt and
Ulysses models. The Dual Hi/Lo (DHL) program will modulate BOTH
lo-beam and hi-beam synchronized. In dark, both projection lamps
will remain On with hi-beam selected.