Kisan Electronics SN-3M User Manual
Page 5
Page - 3
P
P
1
1
1
1
5
5
W
W
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
On most models,
access to the 3-pin
plug of the headlamp
is possible simply by
reaching it from
underneath the front
fairing or from behind
the dash. There is
usually a rubber
splash cover over
the 3-pin plug, which
has to be peeled
back.
Installation is simple: unplug the
headlamp, insert pathBlaze
r
, and then
re-connect the 3-pin plug.
However, you should plan ahead on
where to mount the daylight Sensor. It
can be flush mounted or you can zip–tie
it. Refer to the Instructions on following
pages for:
Choosing appropriate location for
mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.