Kisan Electronics SN-3M - Manual (Page 21)

Page - 19
P P 1 1 1 1 5 5 W W - - D D H H L L I I N N S S T T A A L L L L A A T T I I O O N N : :
n
If you purchased this unit with adapters pre-installed, plug them on the
lo-beam and hi-beam bulbs.
o
Connect the original connectors on appropriate input pins. Polarity of
the original connectors is important. Reversing this connection will inhibit
modulation.
p
Plug the Daylight sensor in and mount pathBlazer with Velcro pad to a
suitable surface.
If you’re installing
the unit as a
universal splice-
in, cut the lo-
beam and hi-
beam wires and
install them in
appropriate
screw-in terminals as shown.
Daylight Sensor can be flush mounted or you can zip–tie it. Refer to the
Instructions on following pages for:
„ Choosing appropriate location for mounting the Daylight Sensor (pg-36)
„ Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.