Kisan Electronics SN-3M User Manual
Page 27
Page - 25
Reverse polarity of original connector will inhibit modulation.
P
P
1
1
1
1
5
5
W
W
-
-
H
H
7
7
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
On most models, access to
the 2-pin plug of the
headlamp is possible simply
by reaching it from
underneath the front fairing
or from behind the dash.
There is usually a rubber
splash cover over the 2-pin
plug, which has to be
peeled back.
n
Unplug the 2-pin headlamp connector and plug the H7 adapter on the
bulb.
o
Now you can plug the original connector on the back of the adapter.
VERIFY POLARITY of the connector as shown above.
You may have to cut a small slit in the cover of the headlight housing to
allow the wires to get inside for connections.
Use the Velcro pad to mount the unit nearby and attach the Daylight
Sensor. It can be flush mounted; otherwise it can be zip-tied – facing the
sky.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.