Kisan Electronics SN-3M User Manual
Page 11
Page - 9
P
P
1
1
1
1
5
5
W
W
-
-
A
A
3
3
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
Locate the 3-pin connector on your bike. To unlatch the 3-pin AMP
connector, push and hold the spring-clip with your thumb as you pull the
connector apart.
n
Plug the 3-pin extension of pathBlazer in headlight housing
o
Now, plug original connector on the pathBlazer.
To latch the
connector, push it in while you keep the spring-clip pushed in with your
thumb. You must have it completely flush before releasing the spring-clip.
p
Plug the Daylight sensor in and mount pathBlazer with Velcro pad to a
suitable surface.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard.
In-line
Plug-in
Install