Kisan Electronics SN-3M User Manual
Page 25
Page - 23
P
P
1
1
1
1
5
5
W
W
-
-
H
H
3
3
-
-
H
H
D
D
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
:
:
n
If you purchased this unit with adapters, install them on the lo-beam
and hi-beam bulbs.
o
Connect ONE of the original connectors to the input pins. Polarity of
the original connectors is important. Reversing this connection will inhibit
modulation.
p
Plug the Daylight sensor in and mount pathBlazer with Velcro pad to a
suitable surface.
You can also splice the power wire
directly in the Input/Output terminals
of the unit. The protective Vinyl boot
to cover the screw-in terminals can be
removed. When connecting this way,
if the polarity is reversed, it will inhibit
modulation. The ground wire to the middle terminal must be attached.
The Daylight Sensor can be flush mounted or you can zip–tie it. Refer to
the Instructions on following pages for:
Choosing appropriate location for mounting the Daylight Sensor (pg-36)
Programming Sensitivity Levels (pg-37)
The Daylight Sensor must be plugged-in for the pathBlazer to
modulate. This is in accordance with the Sec108 requirement of the
Federal DOT Standard