INFICON STM-2 USB Thin Film Rate/Thickness Monitor - Manual (Page 57)

4 - 9
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
4.3.1.2 Simulate Mode
STM-x_win32.VI software allows a simulated deposition without connection to
STM-2. To enable simulate mode, click Find Instruments on the Setup tab and
click Simulate. The Sim Rate hz/sec box will display on the Setup tab. Enter the
rate simulation in hertz per second (see
Figure 4-7 ).
Figure 4-7 Simulate mode
With a rate of hertz per second defined, the software will convert the change in
frequency to Rate in angstroms per second or microgram second per centimeter
squared based on the selection of Thickness or Mass on the Display pane.