5 unpacking and inspection, 6 parts and options overview, 1 base configuration – INFICON STM-2 USB Thin Film Rate/Thickness Monitor User Manual
Page 18: 2 accessories, 1 oscillator kit
1 - 6
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
1.5 Unpacking and Inspection
1
Remove STM-2 from its packaging.
2
Carefully examine STM-2 for damage that may have occurred during shipping.
It is especially important to note obvious rough handling on the outside of the
container. Immediately report any damage to the carrier and to INFICON.
NOTE: Do not discard the packaging material until inventory has been taken and
installation is successful.
3
Refer to the invoice and take inventory.
4
To install STM-2, see
Chapter 2, Installation
.
For additional information or technical assistance, contact INFICON (refer to
).
1.6 Parts and Options Overview
1.6.1 Base Configuration
STM-2 with software and cables . . . PN STM-2
1.6.2 Accessories
5 m (16.4 ft.) USB cable . . . . . . . . . . PN 068-0506
15.2 cm (6 in.) BNC . . . . . . . . . . . . . PN 755-257-G6
1.6.2.1 Oscillator Kit
STM-2 has an internal oscillator, however, an option exists to use an external
oscillator kit to interface the sensor to the controller (see
).
3 m (10 ft.) Oscillator Kit. . . . . . . . . . PN 783-500-109-10
7.6 m (25 ft.) Oscillator Kit . . . . . . . . PN 783-500-109-25
15.2 m (50 ft.) Oscillator Kit . . . . . . . PN 783-500-109-50
22.9 m (75 ft.) Oscillator Kit . . . . . . . PN 783-500-109-75