INFICON STM-2 USB Thin Film Rate/Thickness Monitor - Manual (Page 32)

3 - 6
PN
07
4-
61
3-
P1
A
STM-2 Operating Manual
Density . . . . . . . . . . . . . . . . . . . . . . 0.5 to 99.99
Value in grams per cubic centimeter of
material being deposited. Click in the text box
to edit the density value. For a list of common
material densities, see
Appendix A .
Z-Ratio. . . . . . . . . . . . . . . . . . . . . . . 0.1 to 9.999
Z-Ratio of material being deposited. Click in
the text box to edit the Z-Ratio value. For a
list of Z-Ratios for common materials, see
Appendix A .
Tooling . . . . . . . . . . . . . . . . . . . . . . 10 to 399
Tooling of the sensor connected to STM-2.
Click in the text box to edit the Tooling value.
To determine tooling, see
section 7.3 on
page 7-2 .
3.3.1 File Menu
Click File to open or save a configuration file, to print or capture screen images, or
to exit INFICON STM-2 Software (see
Figure 3-3 ).
Figure 3-3 File menu