Enerpac CDT-Series - Manual (Page 7)

7
CAUTION: Do not exceed oil
temperatures above 150 °F [65 °C].
Use clean, high-quality, hydraulic oil in your
system. Use of Enerpac hydraulic oil, part
number HF series is highly recommended.
Contaminated oil causes premature wear
to moving parts and seals. Frequency
of changing oil depends on operating
conditions and filters within your system,
but you should follow a regular maintenance
schedule. Dispose of used oil properly.
Enerpac offers ready-to-use spare parts kits
for repair and/or replacements. Repair parts
sheets containing parts drawings and parts
lists are available. Contact Enerpac.
Illustration 4 – Manifold for CSM cylinders
Illustration 5 – Manifold for CSM cylinders
Table C5 Manifold dimensions in inches (see illustration 5)
Model ∅ B C D min E SAE Torque O-ring
No. A max Full min Nm (DI X W)
min Thread [ft-lbs]
CSM 271
.97 9 /
16
"-18 UNF .097 .50
1.02
#6 30 [21] .47 x. 078
CSM2131 1.43
CSM571
1.34 7 /
8
"-14 UNF .100 .66
1.14
#10 98 [72] .76 x .097
CSM5131 1.50
CSM1071 1.14
CSM0131 1.63 1 1 /
16
"-12 UNF .130 .75 1.38 #12 150 [108] .92 x .116
CSM10191 1.97
CSM18131
1.91 1 5 / 16
"-12 UN .130 .75
1.54
#16 250 [188] 1.17 x .116
CSM18251 2.28
CSM27151
2.27 1 5 / 8
"-12 UN .132 .75
1.54
#20 400 [295] 1.48 x .118
CSM27251 2.32