Despatch LEB Series - Manual (Page 57)

49
Timer Operation
1. Turn the dials on the timer to the desired time.
2. Turn the Timer switch to ON. The timer is now counting down to zero.
3. Turn the HEATER switch to ON, if it is not already on.
4. When the timer counts down to zero the heater will shut off.
5. To reset the timer, turn the timer switch OFF then to ON.
6. To manually control the time, leave the timer switch OFF.
Timer Configuration
The timer is configured for XX.X hours from our facility. The timer can be easily set up
for different timing ranges. The following are instructions to configure the timer to suit
your needs.
1. Remove power from oven.
2. Remove top cover.
3. Remove socket from rear of timer.
4. Remove timer panel mounting bracket and remove timer from panel.
5. Using a small screwdriver, insert it the adjusting slots for the timer. The slots are
located behind the flange near the front of the timer. See Figure 1 for locations
of switches and displays.
a. Slide the switch to the desired range position.
b. Verify range by looking in face of timer in the range window.
c. Slide the switch to the desired decimal point position.
d. Verify decimal position by looking at the decimal position in face of timer.
6. Remount timer back into panel.
7. Reattach timer socket to timer.
8. Replace top cover.