Despatch LEB Series - Manual (Page 25)

17
Parameter Programming Mode
The control parameters are set through the
Operating and Set-up modes. In most applications,
it is not necessary to alter the oven settings. The
following instructions describe how to access, view
and, if desired, change the parameters.
Once the Operating and Set-up modes are accessed, the SP LED will start blinking
on and off. The CONTROL will not allow the display to be altered improperly.
The CONTROL will automatically exit the Parameter Programming mode if no keys
are pressed for about 2 minutes.
1. Press for three (3) seconds.
2. Press the until the desired parameter is displayed. See Operating and
Set-up Parameter tables on the following pages.
3. Press the or to display value.
4. Use the or to the desired setting.
5. Press the to enter the value.
6. Press and hold the for three (3)
seconds to return to the display mode.
WARNING: Make sure
you understand what you
are changing before
doing so. Changing the
program parameters will
alter the functions of the
CONTROL.
CONTROL Instrument