Align to line boundary, Igure, Lignment – Dascom T2250 User Guide IGP for Dot Matrix Printers User Manual

Page 42: Sing, Igp for dot matrix printers user guide

Text mode
Original mode

IGP for Dot Matrix Printers

User Guide

Figure 12 – Alignment Using ModPlot

Align to Line Boundary

When you are exiting from the Plot Mode and the ModPlot Parameter is OFF it is necessary to
send an Align to Line Boundary Command to advance the paper to the next line down (as
measured from the current TOF). Without this command, characters and graphics would touch.
The escape sequence is:

ESC P @

1B 50 40

This manual is related to the following products:

T2150 User Guide IGP for Dot Matrix Printers T2265+ User Guide IGP for Dot Matrix Printers T2280+ User Guide IGP for Dot Matrix Printers T2365 User Guide IGP for Dot Matrix Printers T2365MC User Guide IGP for Dot Matrix Printers T2380 User Guide IGP for Dot Matrix Printers