beautypg.com

Chapter 1: control panel – Dascom T2250 User Guide IGP for Dot Matrix Printers User Manual

Page 13

background image

Chapter 1: Control Panel

13

Parameter group

Parameter

Description

I/O (continued)
DTR


DTR = DTR*
DTR = READY


DTR signal is assigned to DTR line
READY signal is assigned to DTR line
DTR = Pin 20 (25- pin female connector)
DTR = Pin 4 ( 9- pin female connector)

Interf.

Interf. = Share*
Interf. = Parallel
Interf. = Serial

Selects the interface. Printer is configured
either for parallel or serial connection or in
automatic change for both.
Note: Serial is optional.

Buffer

Buffer =

0 KB


Buffer =

128 KB*

Selects the size of the interface buffer

ETH-INT


IP

Addr





Gateway




Subnet




IP Addr = OCTET1

IP Addr = OCTET4


Gateway = OCTET1

Gateway = OCTET4


Subnet = 0

Subnet = 255

In this parameter group you can choose
settings for the internal Ethernet interface.

This menu level offers the possibility to set the
IP address, which is divided into four digit
groups (octet 1 to 4).
Possible settings: 0 to 255

This menu level offers the possibility to set the
Gateway address, which is divided into four
digit groups (octet 1 to 4).
Possible settings: 0 to 255

This menu level offers the possibility to set the
Subnet mask address , which is divided into
four digit groups (octet 1 to 4).
Possible settings: 0 to 255

Code 7F

Fill*
Ignore
Del Chr
Del Buf
Space

Determines what to do when a 7F character is
parsed in the data stream.

Pr80-9F

Off
On*

Selects whether or not to print characters for
codes 80-9F

Lang

US*
UK
French
German
Italian
Swe/Fin
Nor/Dan
Spanish
Japanese
Portuguese
Fren Eps
UK Eps
Nor/Dan Eps
Ital Eps
Span Eps
Nor Eps
Dan II Eps
Span II Eps
Lat Amer Eps

Selects the language set defined by character
substitution within the ASCII character set in
locations 20 Hex to 7F Hex.