Dascom T2250 User Guide IGP for Dot Matrix Printers - Manual (Page 15)

Chapter 1: Control Panel
15
Parameter group Parameter Description
Paper
Single
Formlen
Lines
Standard
FormAdj
Trac1
Formlen
FormAdj
6
:
72*
:
132
No format
DIN A3
DIN A4
DIN A5
DIN B5
DIN B6
DIN C6
Executive
Letter
Legal
FormAdj = 0/ 72"
:
FormAdj = 12/ 72"*
:
FormAdj = 220/ 72"
(same as above)
(same as above) Selects the paper parameters for Formlen ,
FormAdj and Head, for the Single feed and
Tractor feed forms.
Sets the form length by No of lines of the actual
LPI setting. (E.g. 72 lines at 6 LPI will result in
12 ins form length). Form length may be
selected in the range of 3 ins to 21 ins. Form
length selected will not be affected by changing
LPI later on.
Selects the form length by standard formats.
The LC display will indicate "No format" if a
Form length is selected by the Line function or
ESC sequence, which does not correspond to a
standard format
Sets the first print position of a form in n/72
inch, separately adjustable for each paper path.
NOTE: "Single" does not apply to some printer
models.
AutoTear View/Tear = Off*
View = 1s
View = 3s
View = 6s
Tear = 1s
Tear = 3s
Tear = 6s
Tear at TOF Selects the Auto View / Auto Tear function.
If Auto View is selected, paper will be moved to
make the last printed line visible (Auto View
position). When data is received paper will
move to last print position and printing
continues. If no data is received for the
selected interval paper will be moved to Auto
View position
If Auto Tear is selected, the perforation of the
paper will be moved to the Tear-off position As
soon as data is received the paper will move to
the last print position and printing will continue.
If no data is to be printed for the selected
interval, paper will be moved to Tear-off
position
If the parameter Tear at TOF is set, the paper
perforation is automatically positioned at the
tear off edge as long as the current print
position is TOF. Feeding takes place after
approx. 1.5 sec (hold time). If any data is
received during this period of time printing will
continue and the paper will not be fed to the
tear-off position. It must be noted that the
printer may only be switched off when the print
position is at TOF.