BAND-IT UL9010 Ultra-Lok Tool - Manual (Page 5)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
Ph: 1-800-525-0758
Fax: 1-800-624-3925
Document # P44987 Rev. N
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
www.BAND-IT-IDEX.com
Page 5 of 14
UL9010
Ultra-Lok

Tool
Settings
Recommended Drill Settings:
(Speed-Torque)
½” ¾”
Single Wrap C-2 D-2
Double Wrap D-2 E-4
*Preformed D-2 E-4
Important: Changing the speed setting will alter tension output. Drill switch must be depressed fully by the operator
to attain correct tension when installing clamps. Tension output may be somewhat different depending on condition
and wear of internal components from tool to tool on same setting.
Pre-set tension is achieved when drill stops and on some models, may pulsate. Excessive pulsation (more than
twice) will result in more tension applied to the clamp.
Use of Alternate Drills
NOTE: These torque settings are suggested settings only, individual tools should be adjusted for the clamping
application.
*IMPORTANT:
Larger sizes of preformed clamps (5" and up) may require a lower setting to avoid over-
stressing the lock and creating potentially unsafe assemblies. Inspect lock per instructions on pages 9-11.
Torque
Selector
Speed
Selector
CAUTION!
The UL9010 tool is designed to work mounted securely to the Metabo drill Model SBE 900 IMPULS. Use of any
other drill may result in unsatisfactory performance, hazards to the operator and/or the tool, or unsafe clamps. Use
of alternate drills must be approved in writing by the Director of Engineering at BAND-IT-IDEX, Inc. Disregard of this
caution voids the warranty of the tool and releases BAND-IT of any and all liabilities arising from such misuses.