BAND-IT IT6000-AB 3/8 Tie-Lok Tool - Manual (Page 4)

Document # I17796 Rev F
© Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
www.BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-0307 USA
P: 1-800-525-0758 F: 1-800-624-3925
4 of 38
IT6000-AB
3/8” Tie-Lok
® Tool
Air System
The IT6000 is a pneumatic tool that needs a clean and dry air supply. The BAND-IT Air
Controller Module includes a filter to meet these requirements. For proper tool
performance, the air requirements at the inlet to the BAND-IT Air Controller Module of
the IT6000 must be:
Item Min Max
Inlet Supply Pressure, PSI [kPa] 100 [690] 140 [965]
Inlet Supply Air Flow (SCFM) 1.5 [0.71]
Particle Size In Air Supply (microns) 5
Air Moisture Content 20% RH
Tension Pressure Settings, PSI [kPa] 50 [345] 75 [520]
Cut-off Pressure Setting, PSI [kPa] 100 [690] 110 [760]
Note
– An Air Booster Unit is now available to meet air pressure requirements.
Please have tool model and serial #’s available when calling the factory for
service assistance. Contact BAND-IT-IDEX customer service, 303-320-4555.
Caution
– Do not exceed a Tension pressure of 75 PSI (520 kPa). Pressures
above that may cause premature clamp failure.
Air Controller Module
Cut-off Pressure
Regulator Tension
Pressure
Regulator
Inlet air supply