Atop Technology SW550XC User manual User Manual
Page 69
Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
64
5.2.5
TCP Server Application: Configure SW550xC as a
Pair Connection Master
Pair Connection is useful when pairing up two serial devices over the Ethernet or when it is
impossible to install Virtual COM in the serial device. Pair connection does require two
SW550xC to work in pair, one would be the Pair Connection Master and the other would be the
Pair Connection Slave.
Figure 5.13
Follow
Sec.5.1.1
to configure SW550xC in TCP Server mode properly.
Click on the dropdown box of the Application
option and switch to “Pair Connection
Master
” to enabled Pair Connection application in SW550xC.
Scroll to the bottom of the page and click on “Save & Apply” button to save the
changes.
Remember Pair Connection Master’s IP address here in order to enter this
information in the Slave later.
to configure a Slave to connect to this Master.