Atop Technology SW550XC User manual - Manual (Page 58)

Industrial Wireless Serial Device Server Series
SW550xC User Manual V 1.0
53
5.1.1 Link Mode: Configure SW550xC as a TCP Server
SW550xC Series can be configured as a TCP server in a TCP/IP Network to listen for an
incoming TCP client connection to a serial device. After the connection is established between
the serial device server and the host computer, data can be transmitted in both directions; this
also applies whenever the VCOM is running on server mode. Please be reminded that this is
the device’s default link mode.
Figure 5.2
Figure 5.3
SW550xC defaults in TCP Server mode, there are additional connection settings that can be
configured, Figure 5.3. By selecting the TCP Server mode, a TCP Client program should be
prepared to connect to SW550xC.