AirLive SNMP-GSH2004L - Manual (Page 20)

4. Web Management
AirLive SNMP-GSH2004L User’s Manual 15
Fixed IP: If your ISP has assigned you a fixed IP. Please go to the Switch’s IP
offered
Cable Modem: If your Cable service provider uses DHCP for IP assignment, please
r
hen the configuration is finished, the Remote PC can access the switch by typing the
Conn ct through Broadband Router
y
configuration and enter the IP address, Subnet Mask, and Gateway information
by your ISP. If your ADSL connection is PPPoE or PPTP type, you have to connect
through a router for remote management.
y
turn on the DHCP function under IP configuration. Make sure there is no DHCP serve
in the network. Then the Cable provider will assign the switch with a IP and Gateway.
Go to the console port management to find out what IP has been assigned to the
switch.
W
switch’s IP address on the web browser.
e
If you have an IP sharing router in the network, you can open a virtual server on the router
the diagram above, the router has the WAN (given by the ISP) port IP address
.200”.
On the Switch
tting, set the gateway to Router’s LAN port address 192.168.0.254.
Remote PC
to allow the switch to be managed through Internet. This method is more recommended as
the broadband router provides natural firewall protector from hackers.
In
“201.100.1.5” and LAN port address “192.168.0.254”. The switch’s IP is “192.168.0
Please follow the instruction below to setup the router and switch for remote access:
„ On the IP se
„ Please make sure the subnet mask is the same as the router’s.