AirLive SNMP-GSH2004L - Manual (Page 15)

2. Installation of the Switch
AirLive SNMP-GSH2004L User’s Manual 10
2.7 Connecting to Power
SNMP-GSH2004L features a universal auto-select power supply unit, which allows a power
connection to a wide range of input voltages from 100 to 240VAC @ 50 ~ 60Hz.
To establish its power connection, simply plug the female end of the power cord into the
power connector on the rear of the switch and the male end of the power cord into a
suitable power outlet. Once you have correctly plugged in the power, you can then turn on
the Power Switch to activate the switch.
2.8 Reset to Default
When you forgot your IP or password, please use the mode (reset) button for the factory
default setting. Please take the following steps to reset the Web Smart Switch back to the
original default:
Step 1. Turn on the SNMP-GSH2004L.
Step 2. Press and hold the mode (reset) button continuously for 10 seconds and
release the mode (reset) button.
Step 3. The switch will reboot for 30 seconds and the configuration of switch will
back to the default setting.
Key in the user ID and the password to pass the authentication; the default ID and
Password is as below,
IP Address: 192.168.2.1
Password: airlive