2N Omega series - VoIP manual v1.4 - Manual (Page 73)

73
Now the rules for ME application in the Ethernet module configuration tool
have been created.
The next step is to configure the PBX using the PBX configuration tool.
4.12.5. PBX Settings
You are advised to use the GSM ports in the TDM (digital) section of the PBX
to make the VoIP phone execute the ME function reliably. Use the
2N
®
OMEGA Lite PBX configuration tool to set the required parameters.
4.12.5.1. Incoming Calls to VoIP from PBX TDM
Define that an “empty” number is dialled to VoIP to enable incoming calls from
the TDM section of the PBX. To
do this, use the „I am calling short dialling‟ function
in the ringing table.
Set the short dialling as follows:
Short dials/Common tag