Eppendorf Galaxy Gas Analyzer - Manual (Page 38)

Galaxy® Gas Analyzer — Operating manual
38
8 Maintenance
8 Maintenance
8.1 Introduction
The Galaxy Gas Analyzer should be regularly serviced to ensure correct operation and accurate
readings.
Depending on usage, the O
2
cell should be replaced by the manufacturer every 2 - 3 years.
8.2 Replacement parts
The following parts are supplied by the manufacturer for your use with the Galaxy Gas Analyzer:
8.3 Cleaning
The instrument and accessories (including battery charger) can be wiped clean using a
non-fibrous damp cloth.
NOTICE!
Risk of material damage
 There are no user-servicable parts inside the instrument. Do not attempt to open the gas
analyzer, as this may invalidate the warranty.
Part Used
Sample Filter  Regularly inspect the sample filter, and replace it when you
find signs of damage or discoloration.
 Never operate the instrument without the sample filter, as this
may result in water or dust entering the gas analyzer.
 Replace the filter immediately if water is seen; failure to do so
can damage the instrument.
Sample Tubing  Always inspect the sample tubes to be sure they are not
contaminated or damaged. Replace them as needed.
NOTICE!
Risk of material damage
 Do not apply pressure to the LCD display as this can cause damage.
 Do not apply any moisture to the moisture removal tube on the rear of the instrument as this
may damage.
 Do not use solvents or any other chemical cleaners.
8
Maintenance