Eppendorf Galaxy Gas Analyzer - Manual (Page 27)

27
Galaxy® Gas Analyzer — Operating manual
Abb. 23: Go to reading screen
Fig. 23: Go to reading screen
5. First: Press the numeric key 1 if you wish to go to the first stored reading; use the Scroll keys
to move through this record.
6. Last: Press the numeric key 2 if you wish to go to the last stored reading; use the Scroll keys
to move through this record.
7. Num: If you would like to jump to one specific record, press the numeric key 3, then enter the
number of the reading you wish to see. For example, if you seek record 5 of 10, key in 5, and
the instrument will display record “0005 of 0010”. Use the scroll keys to move through this
record.
8. Press the right-hand (Exit) soft key to return to the Options screen.
5.8.6 Diagnostics
The Diagnostics function enables remote technical support to identify and resolve issues with the
instrument and readings. If required, you may be asked to confirm the diagnostics displayed.
This is not a function you will ordinarily need to use.
To access the Diagnostics screen, if you start in the Main screen, press the Menu key on the
instrument panel, then press the numeric 5 key to view diagnostics. For further information,
contact your equipment supplier.
5.9 Warning and error codes
When turned on the instrument will perform a short predetermined self-test sequence. During
this time, many of the instrument’s working parameters and settings are checked. If any
operational parameters are out of specification or if the pre-programmed recommended
calibration/service date has passed, error codes or warnings may be displayed.
For error codes and warnings, (see Warning messages on p. 39).
5.10 Battery/Charging
The Galaxy Gas Analyzer uses a 2 Ah Lithium-Ion cell battery. A fully charged battery will
operate for 8 - 10 hours with normal operation. Always use the battery charger provided with the
instrument.
When plugged into the charger, the instrument will power on and display “Charging”. A full charge
will take approximately 3 hours.
When charging is complete, the display will change to show that the instrument is “Charged”.
To turn the instrument on while charging, or when “Charged” is displayed, you will need to turn
the instrument off and then on again.
NOTICE!
Risk of material damage
 Always recharge the battery using the charger provided with your Galaxy Gas Analyzer.
Although the instrument can be powered via its USB connector, it cannot be recharged via
USB.
5
Op
er
at
ion