Eppendorf I-26R Large Stackable Incubator Shakers - Manual (Page 31)

31
New Brunswick Operating Manual
8.2 Continuous (Unlimited) Run
1. Press SELECT until the RPM INDICATOR is illuminated.
2. If the display indicates that the shaker is OFF , press the START/STOP KEY .
3. Press either ▲(UP), ▼(DOWN) KEY to enter SET MODE
(the
SET INDICATOR will
illuminate).
4. Set the speed by using the ▲ or ▼ KEY until the desired setpoint is displayed.
Continued pressure on the ▲ or ▼ KEY will cause the setting to change more rapidly.
The setpoint may be changed during a run without stopping the shaker by
following steps 1-4 above.
8.3 Checking Any Setpoint
1. Press SELECT until the desired indicator is illuminated.
2. Briefly press either the ▲ or ▼ KEY to enter the SET MODE and display the current
setpoint.
Holding the ▲ or ▼ for more than 0.5 seconds causes the speed
setpoint to change. Should this occur, resetting will be necessary.
8.4 Timed Functions
The shaker may be programmed to automatically stop after a preset time period of 0.1 to
99.9 hours. There must be power to the shaker in order to set the timer, although a timed
run can be initiated while the unit is either stopped or operating.
To set the timer:
1. Press the
SELECT KEY until the HRS INDICATOR is illuminated.
2. Press either ▲ or ▼ KEY to enter the SET MODE and set the desired run time, between
0.1 and 99.9 hours.
If the shaker is stopped, skip to Step 5 below. If the shaker is already running:
3. Press the START/STOP KEY . The shaker will stop and the display will read OFF .
4. Press the START/STOP KEY again; the TIME INDICATOR will light and the shaker will
start the timed run.
If the shaker is stopped:
5. Press the
START/STOP KEY . The shaker will start in untimed mode.