Eppendorf Temperature Verification System - Manual (Page 32)

Temperature Verification System USB – Single-channel — Operating manual
32
7 Transport, storage and disposal
7 Transport, storage and disposal
7.1 Packing
Proceed as follows to pack the Temperature Verification System USB – Single-channel for
storage or transportation.
1. necessary, decontaminate Temperature sensor or disinfect (see p. 34) the (see p. 33).
2. Pack the system, and all assemblies, in the supplied transport case.
The storage conditions are listed in the Measuring device operating manual.
7.2 Disposal
In case the product is to be disposed of, the relevant legal regulations are to be observed.
Information on the disposal of electrical and electronic devices in the European
Community:
Within the European Community, the disposal of electrical devices is regulated by national
regulations based on EU Directive 2002/96/EC pertaining to waste electrical and electronic
equipment (WEEE).
According to these regulations, any devices supplied after August 13, 2005, in the
business-to-business sphere, to which this product is assigned, may no longer be disposed of in
municipal or domestic waste. To document this, they have been marked with the following
identification:
Do not dispose of batteries together with domestic waste. Dispose of batteries in accordance with
local, legal regulations.
Because disposal regulations may differ from one country to another within the EU, please
contact your supplier if necessary.
WARNING!
WARNING! Risk to health from contaminated device
1. Observe the information in the decontamination certificate, You find it as
a PDF file on our website (www.eppendorf.com/decontamination).
2. Decontaminate all the parts you would like to dispatch.
3. Include the fully completed decontamination certificate in the package.
Hint!
A decontamination certificate must be included when the system is sent to
Eppendorf for recertification or repair.