5 warnings for unintended use – Eppendorf Temperature Verification System User Manual
Page 12
Temperature Verification System USB – Single-channel — Operating manual
12
3.5 Warnings for unintended use
NOTICE!
NOTICE! Material damage from incorrect connections.
Only electrical connections may be made to devices described in the
operating manual.
Other connections are permitted only following consultation and
agreement with Eppendorf AG.
Only connect devices that meet the safety requirements defined in
IEC 60950-1.
CAUTION!
CAUTION! Poor safety due to incorrect accessories and spare parts.
The use of accessories and spare parts other than those recommended by
Eppendorf may impair the safety, functioning and precision of the device.
Eppendorf cannot be held liable or accept any liability for damage resulting
from the use of incorrect or non-recommended accessories and spare parts,
or from the improper use of such equipment.
Only use accessories and original spare parts recommended by
Eppendorf.
NOTICE!
NOTICE! Damage as a result of incorrect packing.
Eppendorf AG is not liable for damage caused by improper packing.
The device may only be stored and transported in its original packaging.
NOTICE!
NOTICE! Damage to the sensor and thermal cycler due to improper use.
Do not insert the sensor into thermal cyclers that are not compatible with
the Temperature Verification System USB – Single-channel.
When inserting the sensor or closing the heated lid, never use an
operational force significantly higher than the force recommended by the
thermal cycler manufacturer for handling a PCR plate.
Eppendorf accepts no warranty or liability for damage caused by incorrect
use of the Temperature Verification System USB – Single-channel.
NOTICE!
NOTICE! Damage to the sensor/cable connection as a result of the
cable being pulled.
Repeatedly pulling on the cable to remove the temperature sensor from the
thermoblock will cause damage to the sensor/cable connection.
Pull the thermosensor out of the thermoblock via the thermosensor
housing.
Do not apply tractive forces to the cable.