Eppendorf Temperature Verification System - Manual (Page 13)

Temperature Verification System USB – Single-channel — Operating manual
13
4 Installation
4 Installation
4.1 Initial charging of the battery
The Measuring device is delivered with a partially charged rechargeable battery.
 Fully charge the battery before using it for the first time.
4.2 Connecting the temperature sensor to the Measuring device
1. Select the temperature sensor that matches the bores in the thermoblock.
2. Connect the temperature sensor grip to the Measuring device using the connecting cable.
Additional information can be found in the Measuring device operating manual.
Hint!
The Initial setup chapter of the Operating manual of the measuring device
contains a description of the initial charging.
The charging time can be found in the technical data.
Hint!
The Measuring device must be switched off before connecting the
temperature sensor and plug head line.
Hint!
Do not remove the sensor when the Measuring device is switched on.
Hint!
Make sure the plug is securely positioned. Do not use force during insertion.
Hint!
Additional information on the push/pull plug connection is available in the
Operating manual of the measuring device.